Difference between revisions of "SW startup guide for VIBE"
From Yantrr Wiki
(Created page with "Below, we describe how to set up the VIBE and the associated software. = Overview = Data connection is established based on PPP protocols. Wvdial is mainly used to configure...") |
|||
| Line 7: | Line 7: | ||
* How to write wvdial conf files for any network | * How to write wvdial conf files for any network | ||
* Sample wvdial.conf file for [[Sample_wvdial.conf_file#Sample_Wvdial_conf_file_for_AT.26T_3G | <big>'''AT&T'''</big>]] and [http://www.yantrr.com/wiki/Sample_wvdial.conf_file#Sample_Wvdial_conf_file_for_TMOBILE_2G <big>'''T-Mobile USA'''</big>] | * Sample wvdial.conf file for [[Sample_wvdial.conf_file#Sample_Wvdial_conf_file_for_AT.26T_3G | <big>'''AT&T'''</big>]] and [http://www.yantrr.com/wiki/Sample_wvdial.conf_file#Sample_Wvdial_conf_file_for_TMOBILE_2G <big>'''T-Mobile USA'''</big>] | ||
| + | |||
| + | = Hardware Configurations = | ||
Revision as of 04:58, 8 July 2015
Below, we describe how to set up the VIBE and the associated software.
Overview
Data connection is established based on PPP protocols. Wvdial is mainly used to configure the dialup settings. For setting up various settings for PPP connection and establishing a data connection on the VIBE follow the link to the wiki
- Way to set up the VIBE
- How to read location and coarse time as NMEA-0183 message from the serial UART ttyO4 port
- How to write wvdial conf files for any network
- Sample wvdial.conf file for AT&T and T-Mobile USA
